Quote:
Originally Posted by sixto
1) If the crank was at TDC, you don't know if it's #1 TDC or #6 TDC.
2) If he hit the starter with the IP out then the cam did not turn in sync with the crank!!! I'd be more concerned about that than getting the IP back in time.
Sixto
93 300SD
|
If the timing is all the way messed up, I would first plug the #1 glow plug hole up with a piece of tissue and turn the crankshaft clock-wise until the tissue POPPED out as the numbers on the crankshaft were heading upwards toward Zero/TDC. The popping out of the tissue would "guarantee" that you were on the compression stroke. Now, it is possible for the tissue to seemingly be pushed out by air on some turns of the crankshaft, but I like to keep trying until it POPS OUT FORCEFULLY, which at that time I know that my chances are good that I am on the compression stroke, which I know I must be on before I can get the timing correct.
Next, I would STOP turning the crankshaft at Zero TDC (
"0/1", you have to be careful because 10 BTDC can easily be MISTAKEN for 0 TDC). Then while at 0 TDC on the crankshaft, I would check to see if the mark at the camshaft bearing holder was in alignment. If not, THEN I would take out the camshaft to set it correctly. Hopefully, no valves would have been bent or broken or pistons busted at this point due to running the engine with the camshaft and crankshaft out of sync.
Once, I got those two marks correct, then dieselsteve's method of setting the IP would definitely work to get the car started.
BenzDiesel