Quote:
Originally Posted by JimZ
I have no clue how to remove IP lines. I could look at it and figure out what's in the way and remove it, but is there anything I need to do when I remove them? Is there any special way to put them back in? etc etc. I wish I had the knowledge you guys have...
|
simple.
17MM wrench, loosen the nuts on each end of the lines and remove. some take the guide clamps or whatever they are off so the lines can be removed individually, but it all goes back together fine if you remove them all together.
putting them back on is just as easy. thread by hand each nut until all nuts are threaded on, then tighten the IP side first, bleed and bleed until no air comes out of the injector side, and then tighten them up.
JOhn