It all started with a clonk when starting from stand still. I search the web and didn't find much - so I thought I add to the shared knowledge.
Note: I'm not a trained MB mechanic and you may not want to do what I did. (I did a similar procedure on my Jeep Wrangler when adding motor mount lifts, but that was very straight forward - lots of room.)
Problem:
Car would make a clonk when starting a forward direction. Being very light on the skinny helped and pushing hard made it lauder. First I thought it was a U-joint or transmission part.
Car: ML430, 90k miles, 2001
Diagnose:
Standing on the break and doing the same thing, still gave the noise - opening the hood showed the engine moving/lifting with the torque - Bad motor mount on drivers side.
How-To:
The local dealer wanted $800+, so I started searching for How-To's. Didn't find much, more than - strip the engine - lift it (out?)...Didn't want that.
Mounts was $44 at the dealer, the transmission mount ca $80.
The drivers side mount is really hidden behind AC-pump, Power-steering, front-diff, exhaust, drive shafts, axle - you name it - it's all there
First I put the car on jack-stands, holding the frame behind the wheels. I removed the plastic engine shield on top and the splash guard underneath. This gave access to the two lower bolts that held the fan shroud - which was loosened.
On driver's side, I removed:
- inner plastic fender (wheel housing liner) - easy
- heat shields behind the fender - messy, two bolts from the front and one from the rear. The rear bolt was a PIA to reach with large hands.
- this gave access to the motor mounts upper bolt from the side.
- the two lower mount bolts was reachable from below, although one was just behind the drive shaft and was another PIA.
- I later also took of the wheel to get better access.
Passenger side was easy: Pull out the airbox - unsnap lid, and inlet from MAF, lift out box. This gave access to the upper bolt and the lower bolts was in open sight from below.
Next step - get the mounts out. I used my garage jack with a wood piece that fit between the cross member and the sway bar. I added another piece to spread the load and then lifted carefully until the car started to follow.
- Passenger side mount came right out.
- Driver side was broken = top part not attached to the rubber. This made it a little larger, so after replacing the passenger side mount, I lowered the engine and moved my lift point to the driver side. With an addition of a gorilla bar, i did get the drivers side out and the new one in.
- To get more play, I also loosened the transmission mount and its cross-member.
Note: putting your hands under any part of the engine when lifted by the jack is not safe.
Put all parts together and no more clunk.
How long: - It felt like forever, but probably some 6+ hours, including searching for dropped bolts and figuring out the next step. Next time would be much faster. Not sure that an engine hoist would help much.
Pic1: Engine jacked up
Pic2: Drivers side motor mount seen from wheel well.
Hop this helps someone.
Cheers