Psfred

Am I doing something wrong? I could only find the brass washer under the valve after I removed the element in the injection pump. I bought the o ring but can't find where to put it. Maybe the o ring goes under the plate that everyone says not to remove.

I put the new brass washer in and tried it, and it seems to have a very very minor leak, only enough to see it in the tread area. I have it torqued properly.

I got the valves adjusted, and two intakes had zero clearance. The exhausts were all about 0.004 inch too tight. I changed both fuel filters.

The car seems to run a little better but not up to standard yet. I have to work on the thermostat as the car never gets above 60 degrees C, and I have to find an oil leak.

Thanks for the help.

Joe