84D. I was going to work on replacing the driveshaft center support on the weekend but I didn't have a large enough open wrench (1 3/4? & 1 5/8?) to loosen the shaft nut (Recently noticed shuddering/vibration at low speeds.) Found the rubber bushing in rough shape.

So, am going to have the wrenches today and try it tonight. I do have some questions if those who have done this work can verify my observations and give me some pointers.

From what I've seen so far, to change the center support bushing & bearing, I don't think I need to remove the front half of the shaft. Just unscrew the shaft nut to remove the rear half of the shaft?

Is the reason for unscrewing the shaft nut because it holds the spline in place? Also, is a puller necessary to remove the bushing/bearing?

I also plan to replace the tranny support while I'm down there. Thanks...

Adding pics below......... got the sleeve nut loosened. Now waiting for center support...

Attached Thumbnails

   

__________________
the sooner you start... the sooner you'll get done If it ain't broke, don't fix it.. Its always simpler to tell the truth...
2007 Honda Accord EX
2007 Honda Accord SE V6
96 C220
97 Explorer - Found Another Home
2000 Honda Accord V6 - Found Another Home
85 300D - Found Another Home
84 300D - Found Another Home
80 300TD - Found Another Home
Previous cars:
96 Caravan
87 Camry
84 Cressida
82 Vanagon
80 Fiesta
78 Nova
Ford Cortina
Opel Kadet
68 Kombi
Contessa