Quote:
Originally Posted by tobybul
Rich, hopefully its still fresh in your mind... how much pushing forward of the driveshaft did you have to do to get it free from the pinion shaft (the stubby shaft coming out of the differential). This thing looks like its sticking out about an 1 1/2 inches..
So, as you can see, I have not lowered the shaft yet so have not gotten to the snap ring. The tranny mount is off but am not putting it back on till the shaft is back on.
|
Kababayan, I see what your problem is. When I removed my driveshaft, I had the differential lowered a bit. This allowed space to get past yoke pin. But since you are not touching the differential. What you need to do is push the driveshaft back into the yoke to its orginal position. Then your going to have to disconnect the shaft from the transmission end. There is no pin there so you can easily slide it out. Once you have it disconnected from the transmission side, you can move the driveshaft forward to clear that pin.
Good luck.