|
the sleeves are indeed dry. i have pressed them out myself at my favorite machinists shop. i used his hydraulic press which will is rated at maybe 80 tons. the force required to get them out is most impressive. it is frightful in fact. if you happen to get the discs which catch the edge of the sleeve wrong i felt that the result could be the destruction of the block by bursting the whole thing. (this could be a wrong impression but the behavior of it all while the pressing is happening suggests this possibility). although if the fsm says you can hammer them out it must be possible, i cannot imagine doing that successfully.
pulling the piston, rod and sleeve out and doing one cylinder sounds good on paper, but the problem is getting the sleeve back in the new home in the same relationship to the piston etc. there is no locating tangs or anything like that.
if i were an okie trying to get to california in the thirties i would attempt a repair like this. otherwise i would not.
a mercedes diesel is a very very complex motor. it takes many many hours to disassemble and reassemble. doing a quck and dirty repair such as this is not in any way cost effective unless you want the experience and are not really concerned with good results.
if it were me?....i wouldn't take a benz diesel apart unless i was going to fix it correctly.
if i were very tight for money i would find a decent used motor and put that in.
the pistons are usually, in my experience reusable. we have replaced some but three out of four times or so we reused them. when we could not we salvaged good used ones from engines with blown rods. they must be measured for wear at the ring lands. my machinist did that.
how is your sleeve damaged? and how did it happen?
tom w
__________________
[SIGPIC] Diesel loving autocrossing grandpa Architect. 08 Dodge 3/4 ton with Cummins & six speed; I have had about 35 benzes. I have a 39 Studebaker Coupe Express pickup in which I have had installed a 617 turbo and a five speed manual.  [SIGPIC]
..I also have a 427 Cobra replica with an aluminum chassis.
|