Iam installing a new engine in the 85. about ready to drop it in. have the
engine compartment all clean and spiffy. don`t know why I didn`t see this
before today.
the frame under the motor mount where the two 6mm bolts thread into,
have cracks around the threaded hole on both sides. the left side is worse
than the right.
I noticed by the wear marks in the paint where the mount rests on the
frame is not even. it seem like most of the weight was on the area around
the hole.

I called a welder this morning, he came over and we discussed what to do
so when he gets back in a little bit we`ll GET ER DONE.

these cracks are under the rubber mount, so never noticed them before,
but then we don`t remove our engines everyday. with 331000 miles
stress do develope over time.

Charlie

__________________
there were three HP ratings on the OM616...

1) Not much power
2) Even less power
3) Not nearly enough power!! 240D w/auto

Anyone that thinks a 240D is slow drives too fast.

80 240D Naturally Exasperated, 4-Spd 388k DD 150mph spedo 3:58 Diff

We are advised to NOT judge ALL Muslims by the actions of a few lunatics, but we are encouraged to judge ALL gun owners by the actions of a few lunatics. Funny how that works