Hey guys Have anyone of you heard of adjusting the ignition switch interlock cable to free up that sticking key problem? I've been having the sticking ignition recently, and checked through a few different forums and about adjusting that ignition switch interlock cable, but I'm not sure where the adjustment is. Is it from inside the car or underneath at the side of the tranny I tried lifting the center console with the window switches but could not see anything that looks like an adjustment I did see the cable but not where it ended somewhere below the gear shifter assembly. However in the process of trouble shooting I did remove the panel below the steering wheel/column the one above the gas and brake pedals, to get to the ignition, and found where the ignition switch interlock ended on the ignition unit assembly it had the silver turning end to it, I twisted it off while the key was in at the first turn position (the one after inserting the key pass the stuck ignition position) and the key turned like silk but it just wont come out of the ignition, I was tempted to leave a key in the ignition and keep it concealed to eliminate the sticking problem, but the thought of someone getting into the car and having easy access to starting and driving off with it, slapped sense back into me. But the point is that it turned flawlessly like silk with the ignition switch interlock cable detached, which seems to tell me that the tumbler is working fine so it must be something with that cable that's causing the problem. Any ideas and does anyone know where the adjustment for that cable is and how to adjust it?