Thanks for replys everyone, here are the fault codes..
2 max retard acheived
3 coolant temp B1/9 from LH2-sfi implausable
4 load sensor in dist ign 1 (d11) N1/3
5KNOCK SENSORS 1 OR 2 A16G1/2
6 C/S postion sensor L5/1
7 Knock control analysis curcuit in dist 1 (d11) N1/3
8 Trans load protect switch S65 does not close
11 Ref resistor R16/2
12 TN eng speed signal output short curct
8108 unknown
8110 unknown
15 output stage1 dist ignition1 (d11) N1/3 ignition primary open
16 as above stage 2
18 magnets for crank post not recognised L5
20 DTC memory dist 1
21 load sensor dist 1
8210 unknown
8220 unknown
8240 unknown
28 no CAN reception from EA, CC,ISC
8303 unknown
The cap and rotors were changed after the fault occured but did not improve matters.
16 output stage2