Quote:
Originally Posted by spit64
I used the LED tool on the 8 pin.
|
Very Good
You guys are getting hip...
Try cleaning the MAF and see what happens ..don't touch the film inside ..just spray it good and let it dry.
Then , after maf install, go back to pin 8 with the led tool and clear until you get a single flash back...[ meaning no code]..then wait 2 secs after single flash, hold button for 6/7 secs , turn key off for 10 secs , On for 10, then start car..that will bring base line memory back to zero for adaptation.
Drive car a couple of days for adaptation and then go into 8 again for a check... you mat need a Maf , but sometimes this works if they are dirty from a bad air filter.
That CRC MaF stuff is good..