View Single Post
  #11  
Old 07-30-2008, 04:08 PM
rocky raccoon rocky raccoon is offline
Registered User
 
Join Date: Oct 2007
Location: Greater Metropolitan Beaverdam VA
Posts: 2,860
for Dee8Go

There are only four bolts holding down each of your cam covers. If they are not evenly torqued an oil leak often results. There is also the danger of stripping the threads in your aluminum head if overtightened. The torque spec is 3 to 4 Nm. Some people are mechanically "sensitive" and have a feel for such things. Those that are not would be well served with a torque wrench. The small bolts holding down your covers are best torqued using a small 1/4" drive torque wrench. A larger wrench may not be sensitive enough for the small values specified.

While the covers are off, the plastic fittings serving your cam oiler tubes are right in front of your eyes. Check them out. They may be coffee colored but that does not mean they are bad. They are easy to change and cost very little if you want to do that. With the cam covers off you can also assess the state of stretch on your cam chain and the condition of the upper chain guides and tensioner. There are plenty of posts on this forum offering help to do those things.

Time to R&R cam covers estimated at 30 minutes right side, an hour left side.

Good luck Pal. Hope to see you again at a GTG.

Last edited by rocky raccoon; 07-30-2008 at 04:10 PM. Reason: add information
Reply With Quote