I checked the 3 fuses (not 4) on the Base Module and swapped them out just as a precautionary.

Also after re-reading my thread..Let me make it clear what happened. I grounded pin 3 (+V) on the X11/4 to the metal module base. I got a small spark.

and the explanation of the codes are:
pin 4- code 20-No CAN data transmission from LF-SFI control module
pin 7- code 7-No CAN data bus signal from EA/CC/ISC,ABS/ASR,HFM-SFI or LF-SFI control module faulty.
pin 8- code 9-m104, 119 LH-SFI control module voltage supply, open circuit
pin 19-nothing, doesn't even tell me it's OK.
I've checked all the fuses I could find and before I start spending money on a module I wanted to see what else to check of if there is any more troubleshooting I can do.

Mark