|
David:
The cd changer you posted an image of isn't the factory one. if it interfaces with the radio controls, then fine. I am unsure if it will attach to a factory bracket or not. Yes, the bracket was always sold seperately from the changer, 2 different part numbers. On the 202, if you raise the trunk floor mat, you will see 2 pre-drilled holes, this is where the top screws for the bracket screw in. There is no bottom screws. instead, there is a short metal rod, that sticks through the inside wall of the pocket, it's angled down slightly. The rod is engaged into a corresponding hole in the wall, then the bracket drops down more so that you can start the screws, Tightening the screws wedges the whole bracket sturdily into place.
Let me know if you need the part number for the bracket. I don't know if the holes for attaching the cd changer match up with what's in the changer. You are supposed to attach the changer to the bracket, then install the bracket to the car. Make sure the orientation of the bracket is set to Vertical.
Gilly
|