http://www.peachparts.com/shopforu...ad.php?t=99833

with this if it comes out you can rebuild that unit you have - i put it on a zip and than copied it to paper works better for me --

please note : you must get the special sealing kits for the 2 drums as the O rings under the riverted plates get hard and if you dont replace them it will slip into gear like a worn out trans - the pressure will blead off its not hard to do - drill out tap to 10/24 install screws instead of riverts and trim - comes with directions just make sure you are carefull with the one plate if the screw heads are not flush the clutch piston wont go all the way to the bottom and the discs wont have enough clearence to operate corectly - we belt sand the screws down a bit look at what to do and use that trick you will see why, care must be taken with the depth of the drilling for the taper heads of the screws as well , too much and you will need a new drum plate -- look at all before you do it to ensure you have what needs to be done -- jz