For my 18th birthday, my parents told me they would buy me some car parts. I will list the entire shibang right now, and the ones that they are buying for me with have a * by them
2 brake wear sensors*
front brake pads*
2 ball joints*
drag link*
Injection pump rack dampener pin/screw*
tie rods
idler arm repair kit
rear subframe mounts
rear brake pads(OEM ones, tired of the squeaking)
rear tranny mount
rear differential mount
can of diesel purge
inline fuel filter
main fuel filter

Now, firstly, am i forgetting anything? secondly, i'm really confused as what on earth i need reguarding the tie rods. I found, tie rod ends, center tie rod, left and right tie rod, right hand thread, left hand thread, some other wierd one.....what do i need reguarding those???? Also, what kind of tools do i need to rent other than the ball joint press tool? someone told me the center tie rod is the drag link, is that correct? Do you think i should replace anything else while i'm at all of this? And lastly, based on you alls experiance will this significantly tighten up a worn out front end? thanks
Ryan

__________________
83 300SD.......sold
96 integra SE....sold
99 a4 quattro....sold
2001 IS300.......sold
2002 330i.........current.
2004 highlander limited....current.