Picture time!

I have a video uploading as well.


SLS fluid level was fine, right at the max. However I could NOT tell if it was moving or not. The engine vibration was moving it a little bit, but I don't know if it should move at all unless the valve commands it to.


The valve, although covered with the underliner stuff, looks dry as can be.


Distant shot of the differential. What am I looking for?


One accumulator. Looked dry.


Better shot of my wheel gap.


Better shot of the differential.


This isn't what I'm looking for, is it?


Second accumulator, also dry.


Other side of the valve. This is while running, is the position of the lever correct? Man I so badly want to clean that thing!


More valve.


Valve again. Is that hose kinked?

Give it a few minutes to process, but here is a video of my SLS. My camera cut out after a minute, which sucks, but there is a good 30 seconds after the start where nothing happens. No raise at all. Cold start too by the way

http://www.youtube.com/watch?v=474Nqz5ehio