Quote:
Originally Posted by Arthur Dalton
It should be way up on the firewall , behind the booster section..that is why I mention full hood ..
Just look for a 3 wire connector with those colored wires.................. those wires all go down to the blower compartment.
Which is why we use that connector before pulling everything apart. [ X/64 connector]
If you can't find it on that chassis , I will look it up in the Location Pictorals
|
Thanks Arthur. I have been away and just had a chance to look for the connector. I think I found the right one, behind the booser and a little higher. It is a tight squeeze for a hand. So I got the connector separated. The block that stays on the firewall has 3 pins that correspond to the Red,Black,Yellow wires on the connector.
First question: I believe these pins at the connector block on the firewall are where I should check for voltage, right? The wires on the connector that I can pull out I believe go down to the fan.
Second question: If the pins back on the firewall are the right place to measure voltage, what is the best way to connect to them? It is tight, so is a clip best?
Thanks!