|
Step 10: Picture of rear driveshaft with old carrier bearing and bracket removed. Also pictured are the new carrier bearing and bracket.
Step 11: Press the new carrier bearing into the bracket. I lubed the bracket with dishwashing liquid and pressed the carrier bearing in with my hands.
Step 12: The new carrier bearing and bracket are installed on the driveshaft. Don't forget to reinstall the circlip! The bracket has a shoulder which must face the rear of the car upon installation. The bearing rests against the shoulder when you press it into the bracket. Picture it like this - if you were to pull the bracket off the driveshaft, it would take the carrier bearing with it.
The last picture is of the gigantic wrenches you will need. Many of your parts/bolts may be rusted in place so be patient. My rear flex disc was seized to the driveshaft so I had to remove the flex disc from the differential to get it out of the car. You may be luckier than I was. Make sure you realign everything to match the marks you made upon installation so nothing is out of balance.
Good luck!
Scott
__________________
Scott
1982 Mercedes 240D, 4 speed, 275,000
1988 Porsche 944 Turbo S (70,000)
1987 Porsche 911 Coupe 109,000 (sold)
1998 Mercedes E300 TurboDiesel 147,000 (sold)
1985 Mercedes 300D 227,000 (totaled by inattentive driver with no insurance!)
1997 Mercedes E300 Diesel 236,000 (sold)
1995 Ducati 900SS (sold)
1987 VW Jetta GLI 157,000 (sold)
1986 Camaro 125,000 (sold - P.O.S.)
1977 Corvette L82 125,000 (sold)
1965 Pontiac GTO 15,000 restored (sold)
Last edited by Scott98; 04-16-2009 at 10:16 PM.
|