Quote:
Originally Posted by gskurka
If a new injector heat shield doesn't stop the leak, the pre-combustion chamber might be leaking at the flange where it contacts the cylinder head. You'll need a special socket to remove the ring holding the chamber. In either case, make sure you thoroughly clean the mating surfaces and use a torque wrench to tighten things properly. I used some high temperature RTV silicone when I re-installed the pre-combustion chambers.
|
Thank you for the reply and advice,I removed everything down to the head assembly and cleaned everything with brass wire brushes,then reassembled everything(I used a thin coat of high temp copper RTV on the seat,shoulder,and in the alignment groove of the chamber)I tightened everything to spec and let it sit about 18 hours,when I started the car today my problem was cured!! Thanks again for your time and advice.