ran out and checked some more. When energized(key in preheat) I get nothing 0 V at the gp nut on #1 or #2 (didn't check further). The pins with connector off are getting 11 V.

Also, the resistance between gp1 and 2 or 2 and 4 is 1.6 Ohms. The same checking the other end between pin holes 1 and 2 (with connector off). Does this make sense? I'm not sure it does but am reaching my limits here. It is like something is amiss when everything is connected up, no voltage on any gp bolt that I checked. Is there a dead short somewhere that could cause this or is there something more sophisticated happening here?