I still have not sold my truck, which needs to be gone before I buy my MB Diesel . . . this past week on the way home from church my wife says "what is that clunk?"

So today I get home from work early and go out after lunch and have a look at my GMC, the wheel bearing is loose, so I pull it out and clean it up and the race is PLASTIC! I sure hope MB doesn't do things like that! (yes it does has 126k on it)



It has been awhile since I have played with wheel bearings, but when I pulled the cotter pin the nut was loose, I could turn it in about 1/4 turn with my fingers! It looked OK, so after I cleaned it out, I repacked it with grease, and put it back in! Should be OK, I just don't remember about the deal if it is too loose, can I just tighten it up, how long do you think it will last?

I also discovered my "clunk", it was one end of of my anti sway bar flopping around . . . sorry it's kinda fuzzy . .


So at least with these things fixed, I'll feel better about selling it . . .