|
If you were a machinist and could weld, something built from an FI manifold could be constructed.
If you want something factory/bolt on, find an M123 intake manifold (that's the 2.5l motor, not the W123 car). Same bolt pattern as the M180 in your car, except it holds a solex 4A1 carb (four-barrell rochester carb look-alike).
Onto this manifold, you can put an adapter plate and simple TBI setup and megasquirt your car.
The hard part is finding that manifold, as the M123 was never imported to the US. Reach out to the UK, German or Aussie guys here for one.
Your next best bet is the M180 unimog intake. Also a relatively rare part, but findable.
Lastly, you can use two trottle bodies on the original intake. Getting them to balance will be interesting though.
-CTH
|