Thanks for the reply,
wow - its a simpler so far job than I thought, yet I did not do anything, I quit before finishing, put the sls bolts back on and tightened the 6 m6's for the accumulators, the reason i stopped, the 10mm hex bolts holding the line to the base of the accumulator, I tried going in with the long end of the allen wrench and its a ballend, then i applied mass pressure to break it, but it wont budge, went to local hardware store and they do not carry the 10mm hex socket that i feel is needed to break the shcs. Sprayed it heavily w/ liquid wrench. So I am happy to see that the nuts are in good condition and will come off w/o grinding yet bummed that my linkage to the sls is seemingly out of alignment, this may not be a big issue though. Worried for sure about the reconnection of the hydal lines to the new accumulators seemingly they are fixed.
Anyways I will post the results of tommorows next attempt