Just want to make sure I got this right...Correct me on any steps please!
1) Clean inside compressor using the ester oil and turning by hand until it comes out clean. Do I use compressed air after this? Add 20ml oil
2) Condenser needs to have the A/C Flush done to it followed by compressed air. No oil added. Does it matter which end flush it?
3) All hoses A/C Flush then compressed air (no filters/mufflers on our hoses? I'm reading you cannot flush these) Evap -> Compressor line = 10ml oil, Compressor -> Condenser line = 10ml oil
4) Expansion Valve/Evaporator....Leave it alone since it is new. Connect last. Add 40ml oil to evaporator.
5) R/D Leave it alone. Connect last - Add 10ml Oil
6) Connect everything up.
7) Evacuate system for X hours?
8) Fill system with 120ml oil and 2.4lbs of R12.
Is it really 120ml or 120ml minus what I put in stated above?
All done!?
--
Thanks again Larry. I really appreciate all your input. Couldn't have done it without you! Never done this before. I'm good at doing...just need a little instruction along the way
