I have tried to pull these lines when at PNP. and about every one has been so corroded the fittings just rounded off.

I finally bit the bullet and bought the section from the Slave Cylinder end. It comes as a straight piece with the rubber hose on the end.

I used the old line as a guide to bend the new section. when the line is warm, it bend easily between your thumbs. just go slow.

I suppose you can get a piece from an auto supply, then you will need to fab the ends and a rubber hose to connect the 2 pieces together.

Charlie

__________________
there were three HP ratings on the OM616...

1) Not much power
2) Even less power
3) Not nearly enough power!! 240D w/auto

Anyone that thinks a 240D is slow drives too fast.

80 240D Naturally Exasperated, 4-Spd 388k DD 150mph spedo 3:58 Diff

We are advised to NOT judge ALL Muslims by the actions of a few lunatics, but we are encouraged to judge ALL gun owners by the actions of a few lunatics. Funny how that works