Quote:
Originally Posted by Billybob
If you install it with the hood completely open at 90 degrees it stay's in place easily. Use a couple pieces of masking tape on the hood and on the pad centerlines top and bottom as registration marks, spray adhesive on the hood underside and then in the pad's topside. Let it set up until tacky, fold the pad in half lengthwise and hold it folded with a couple clothes line clips. Then place the tape on the pad onto the tap on the hood at the center line at the top of the open hood and then at the bottom, take off the clips and lay one side onto the hood and then the other. Once it touches adhesive to adhesive it's not going anywhere. Let it stay like that for an hour and you shouldn't have a problem after that.
|
Sounds good. I followed a similar approach for the centering but I positioned and held the pad in place with magnets then removed the magnets from half the pad, folded it back and applied the adhesive. Unfolded to seat into the adhesive and secured with the magnets. Then did the other half. I don't know what they were intended for but the magnets that worked best were about 3-4 inches in diameter and had a knob for a handle on one side (looked a lot like a lid for a pan).