Quote:
Originally Posted by kinghais
i just replace the Thermostat n flush the coolant by opening the screw from bottom of the radiator , i did a quick start when the Radiator screw n thermostat was open to c if i can get more coolant out but nothing out.
so i put thermostat n closed the screw. i start it n the temp is going up but no Heat inside, blowing cold air n it seams like coolant is not circulating.
Temp goes high n the 2 fans in front turns on.
how do i bleed air ???
is it possible i broke the water pump
|
Your 96 E300D has a bolt at the front of the block for the purpose of getting the air out of the cooling system. It has a very flat head, take it out, fill the block and coolant tank until it runs out of the hole where the bolt came out of. Replace the bolt, and then warm up the engine and re adjust coolant level in expansion tank if needed.