Thread: I was right, how to properly tighten your carrier bearing support.
View Single Post
  #3  
Old 11-06-2010, 09:45 AM
snookwhaler's Avatar
snookwhaler snookwhaler is offline
Linesider
  
Join Date: Feb 2009
Location: Treasure Coast, FL
Posts: 1,417
How do you get under the car to do that if it is on the ground. It is hard enough to reach those 2 little bolts with the car in the air.

I'm asking, because when I replaced my rear end a few months back I tightened those 2 little bolts with "the car in the air". I knew about this at the time and could not figure how to get underneath the car to tighten them (with the car on the ground).

Are you guys putting the car back on ramps, using a "Pit" or what?
__________________
AJ

1985 300D (SOLD)

Reply With Quote