Hi Arthur,

I just replaced some front end components and am planning a visit to the allignment shop. I was hoping you would see this post and offer me the instructions on making the measurement device for doing an allignment. I am anxious to try and then compare with the results from the shop.

As you mentioned getting measurements between the front and back of the front wheels is not possible becuase I don't have a clear shot. Stuff under the car gets in the way.

Thanks,
Joel

I am also curious as to how I would get a precise measurement, for example if I use a tape measure I could not precisely line up to wheel. Would have to bend measure like when framing and get probably at least and 1/8 of inch off.