View Single Post
Old 02-20-2011, 03:54 AM
JohnM. JohnM. is offline
Registered User
Join Date: Dec 2007
Location: NorCal
Posts: 1,332
OK. These are VERY tricky to remove without bending the trim. There are only two phillips screws at the very bottom of the rear window trim (open the trunk to see them, under the rubber piece). Other than that, the trim just sits in a grooved channel in the window rubber. I have removed one succesfully with two flat bladed screw drivers, but scratched the paint (it was a junkyard car). One I bent at the very end of removal. And on one car I broke the rear glass. So two soft tipped, but stout pry tools are needed. One on each side of trim and just pop it loose little by little. There is actually an FSM on this, I might be able to find it.
1991 300E - 212K and rising fast...
Reply With Quote