|
This will take a lot of patience..
you use a shop vac and pull all the loose rust you can from the area..
then you get a powered steel wire brush to everything you can reach... and vacuum again..
then , most important, you get a " PICK HAMMER " a body working hammer with a sharp end...and you start hitting the rusted areas and a little further out where it does not look rusted..
That is going to show you where your metal is GONE..and where you may have some strength to work from...
do that... get good pictures...and post them... we can go from there...
Pm me as soon as you post them in case I am not paying attention.... Greg
|