Here's the codes in "module" format . . "pins" confuse me ..
Module - Pin - Code# - Description
LH-SFI -- 4 ---- 4 --- Voltage at mass air sensor with hot wire circuit; open or short circuit
Base ---- 8 ---- 5 --- Maximum permissible temperature in module box exceeded
--------- 8 ---- 6 --- Electromagnetic a/c compressor clutch blocked
--------- 8 --- 12 --- Voltage supply for ABS control module, ABS/ASR control module or ASD control module interrupted
ABS ----- 6 --- 30 --- CAN data line to electronic accelerator/cruise control/ idle speed control module
EA/CC/ISC 7 ---- 3 --- Right EA/CC/ISC actuator (left cylinder bank) (M16/1)
--------- 7 ---- 5 --- Stop lamp switch (S9/1)
--------- 7 ---- 6 --- Starter lock-out/backup lamp switch
--------- 7 --- 14 --- Closed throttle position contact switch
Has the wiring harness been replaced . . ?? If so, it certainly looks like a going bad ETA or supporting 'switches".
Also the "LH" voltage is a strange code w/ an ETA failure. You may want to check it out . . .
What about a CEL?? Is it not lighted?? If so, check pin 19, there s/b some codes there.
Finally, read Menu#24 . .
here