I am adding keyless entry to my 85 300D. I have an alarm system, two wire door lock actuator and a few relays. The actuator install is straightforward, but my lack of electrical experience is giving me problems in regards to the wiring.

I have a 'ProSecurity K20' system with the following outputs:



I have two relays and am using the following the wiring scenario (in my case green/black and blue/black are being used like green and blue in the diagram):



The system lights up and makes an audible clicking sound when the lock/unlock buttons on the keyfob are pressed, however the door actuator is not doing anything.

Anyone have some suggestions as to what I have done wrong here? Thanks.