Quote:
Originally Posted by HuskyMan
Replaced all the bulbs with Osrams, finally the exterior lamp out warning indicator turned OFF. However, when I press on the brake pedal there are still no brake lights. So....I took an emery board to #6 fuse and removed the lamp control module relay and cleaned the contacts with an emery board then sprayed everything with electronics cleaner. I then allowed it all to dry then reassembled. Still no brake lights! I'm thinking I need to check the brake light switch under the brake pedal........what is the best way to check it out?
|
Un-plug the wire connector, key on check for voltage, do not re-connect the wire until after the switch is tested.
Ohm test the switch brake pedal applied and off, no change = bad switch.
.
__________________
ASE Master Mechanic
Prototype R&D/testing:
Thermal & Aerodynamic System Engineering (TASE) Senior vehicle instrumentation technician.
Noise Vibration and Harshness (NVH).
Dynamometer.
Heat exchanger durability.
HV-A/C Climate Control.
Vehicle build.
Fleet Durability
Technical Quality Auditor.
Automotive Technical Writer
1985 300SD
1983 300D
https://www.boldegoist.com/