so i'm trying to do a throttle adjustment. with pedal floored i still could gain another inch of travel in the linkage before hitting the full throttle stop.

when i loosened (and then completely removed) the hex screw on the regulating shaft, nothing seemed to budge. can get a flat head in between them and sort of lightly pry them apart, but thats about it. i'm assuming that the two pieces connected by the hex screw are supposed to move up and down independently of each other?

i'll continue with my WD40 and light (and slightly harder) tapping to free the pieces of each other, but thought i should check and make sure that is actually the desired effect i should be trying to achieve before really knocking it around too much....

Attached Thumbnails