Quote:
Originally Posted by daw_two
Okay, I have almost the exact opposite problem. My high beams work too much. When I place the combination switch in the dim position, the high beams may still be on. If I barely pull the stalk toward me, then the high beams will go off; leaving the low beams on. 30 seconds later (maybe 3 minutes later), depending, I look down and the high beams are on. This is much more visible at night.
Is it the combination switch or relay?
|
Daw_Two I think you need to check continuity in the combination switch first. You'll need a multi meter and pull off the lower panel but it's pretty easy.
Check out post #8 on this thread as to what pins to check.
http://www.peachparts.com/shopforum/diesel-discussion/236946-dead-high-beams.html
Check them when the combination switch is in high and when it is not. If you get continuity when it is not in high beam position then it's the combination switch.