Thread: tensioner problem
View Single Post
  #7  
Old 02-01-2013, 06:06 PM
Ferdman Ferdman is offline
Registered User
  
Join Date: Aug 2002
Location: Southeastern PA
Posts: 3,077
244brick, did you only loosen the 19mm bolt a few turns, or did you completely remove it? If you completely removed it there is a chance it's misaligned with the threaded hole. Use a drift pin to align the tensioner with the hole, and try again. If you only loosened the bolt a few turns then the threads must be stripped.
__________________
Fred Hoelzle
Reply With Quote