Hey,

I am swapping a 1991 2.5L diesel into a 1997 Jeep Wrangler and nearing the end...in more ways than one. I believe that I have stepped down the motor from electrical to mechanical based on helpful posts from this site.

So, I want to have the engine stop when I turn off the key. I have read about om617 engines using the eng. overload valve. I would like to do the same. Below I have a photo with what I hope is the 962's overload valve.

1. Do I plug the outlets from the alda to the "Charge Air distributor"?

2. If I connect one end of the tubing to the overload from the "Stop Unit" where should I connect the opposite?

3. With power on the circuit should be closed to run/open to stop?

4. Should I close off or loop all the auto trans vacuum lines since I am running a manual.

I am going off of the pdf for a vacuum line routing on a 602.96 w/ manual from my MB manual.
Thanks




http://www.peachparts.com/shopforum/attachments/diesel-discussion/110244d1363538504-installation-om602-961-into-tn-van-0500-m.-vacuum-circuit-diagrams-engine-602.96-m_t-model-124-201-standard-.pdf