I am going to be pulling the front and rear sway bars on a 1980 300TD tomorrow for future install on my 300D.

I will not have a complete set of tools available. I'll have most normal stuff, though. Sockets, wrenches, vice grips, hammer, yadda yadda.

I looked at the FSM and it sounds fairly straight forward, however the description and pictures are a bit short on this section.

Are there any gotchas to these two jobs?

Thanks in advance for guidance.

__________________
1979 300D 040 Black on Black - 1985 300D Maaco job (sadly sprayed over 199 Black Pearl Metallic) on Palamino

http://i.imgur.com/LslW733.jpg

The Baja Arizona Oil Burners Send a message if you'd like to join the fun
Left to Right - UberWasser, Iridium, Stuttgart-->Seattle,, mannys9130

Visit the W123 page on iFixit for over 70 helpful DIY guides!