Quote:
Originally Posted by cooljjay
The other end that the sensor tube hooks onto....has usually fallen a bit down...its right about the kick panel, really close to the frame.....if you have the knee panel removed....you will see the plastic tube that runs out the frame for the outside sensor...it y's off that.
|
Finally getting back into this. Tested it with a known good spare blower motor, no luck.
Now for the outside sensor issue:
There isn't anything there that looks like it is supposed to connect up to the intake in the speaker opening.
I DO have a long tube (say 5") with 90 degree bends at each end, one end of which is connected to the junction where the outside air intake comes in. The other end was sitting over toward the center console when I found it.
Is this just some random tube someone stuck on there, or is there a piece or pieces missing in the equation? Not clear how this was ever supposed to facilitate the connection.
Also have two open vacuum lines, one white one black. The white is I believe the intentional bleed line... the black one was hiding. Any ideas on where it lives? I cannot see anything (lots of black sh** under there).
Thanks