Quote:
Originally Posted by DrLou
Next (when?) I gotta replace the transmission output seal and re-seat/torque down the output shaft yoke. Play in the output shaft was, I'm sure, responsible for much of the wear in the driveshaft components.
Still not clear if there's a bearing on the trans output shaft to be replaced.
|
I just did this on my 78, the nut had backed off...causing the yoke/flange to come off thus the trans stop working. There is no bearing that needs replacing just the seal. You also don't want to reuse the nut. Get a new one and then torque it down....chances are you will have the older slot nut needing a special socket.