|
NOT SOLVED
Update on the slk 230 * * * After putting in the new conductor plate and refilling the fluid it worked fine except the lights. I took it to the shop and did a full scan and about 8 pages of fault codes came out. They cleared the codes and everything was fine till I moved the car. I went around the block and the check engine came on we then ran the codes again and the only codes were
ETC
P2401 left rear wheel rpm signal is implausible
ESM
P1861 same detail as above
ME-SFI Can message from control module ESP . Vehicle speed signal implausible (P0500)
ESP
C1102-004 l6/3 (left rear speed sensor) loose contact
BAS
C1025-002 CAN bus: CAN message ABS is faulty
plus a couple of codes not related Like gps antenna and alarm horn .
I ordered a new Left rear wheel rpm sensor but have not received it.
2 Questions 1 is the wiring to the RPM sensors in the long narrow connector in front of the break hoses?
second is where is the TCM located so I can check if there is any fluid that migrated into that, there was a lot of leaking around the seal that connects to the connector plate.
thanks for helping as I can't find a manual for this car.
|