I have a small 3 jaw Puller, and had the same problem, just slipped out.
Used another one a machinist friend has, and the same thing. That is when I cut it out with the Dremel.

I measured mine with a set of calipers and determined it was a 34mm hole.

The bearing is a standard sealed bearing. think the size is 34 x 15 x 11 mm.
I originally ordered 2 here off pelican, one a FAG and the other a SKF just to see the difference.
No difference, made in two different countries. SKF made in Korea.

I did a lot of searching to find a 34 x 15 x 11mm bearing, nothing out there.
I have ordered bearings from www.vxb.com (think that`s right) for my Datsun/Nissan Transmissions.
They carry the good Japanese bearings these trans use. I bought a bag of the 34 x 15 x 11mm for a good price, but made in China.
We`ll see how long they last.

That link doesn`t seem to work???

Googled it.

Ball Bearings | Bearing Specialist | VXB Bearings Online

Charlie

__________________
there were three HP ratings on the OM616...

1) Not much power
2) Even less power
3) Not nearly enough power!! 240D w/auto

Anyone that thinks a 240D is slow drives too fast.

80 240D Naturally Exasperated, 4-Spd 388k DD 150mph spedo 3:58 Diff

We are advised to NOT judge ALL Muslims by the actions of a few lunatics, but we are encouraged to judge ALL gun owners by the actions of a few lunatics. Funny how that works