Oh ok stretch so you left the flywheel on and mounted to the 1 1/2" aluminum intermediate plate thats in between the block and trans. Im not sure if I will do this yet but if I do I will make sure to not leave it on there for too long and would try to give it some extra support in front as to take some od the weight off it as I realize that it is much better to mount right to rear of block just did not want to crack the f.w. bolts lose or the extra expense of 12 new bolts. Question on the f.w. bolts it is mentioned that if they are measured and found to be in spec they can be reused where do you measure from and would a ruler do cause I dont know if my micrometer will open up that wide if measureing from tip to tip.