Here's an update on my progress. I've installed all new piston rings and installed the pistons/rods. I torqued down main caps and rod caps. One piston had a scratch on the side, but in the cylinder liner, there was no noticeable scratch. I installed the oil pump. Tomorrow, I will install the upper and lower oil pans and might get the new front main seal in place. From what I've seen, you should never reuse the pins in the harmonic balancer? Is it a risk of them falling out?

New piston rings
12336219_1067010230017242_199216463_n by David S, on Flickr

Scratch on piston #5
12335955_1067010316683900_285209423_n by David S, on Flickr

All installed
11653371_1067010386683893_2108828578_n by David S, on Flickr

Oil pump in place
12358207_1067479366636995_1171025191_n by David S, on Flickr

12346895_1067479423303656_1852781643_n by David S, on Flickr