Pulled my module out.
Remove the module next to it to get better clearance. It has only 13 pins so comes out fairly easily. Rock the lamp monitor module back and forth to evenly pull it out of the sockets. On mine the 8 and 10 pin connectors came out of the connector holder and stayed on the module. Not sure if they were suppose to do that or stay in the holder. Pressed them off with a small screwdriver.
If you have one of those tools with the hook to pull the instrument cluster, it looks like the job would be easier as there are spots where you could get it under the module to help rock and pull it out. You could improvise with a piece of coat hanger wire but it is doable without, just hard on the fingers.

Edit: Helps to get at the relay center if the hood is put in the vertical service position.