Ok, I installed these parts this weekend. Everything went in just how it should and fit perfectly. If any one was wondering I did not buy any tools. I drilled a hole in the end of a steel bar for the 8mm hex key and used a hose clamp to secure it and I used vise grips with leather to grab and secure the water pump pulley. it really when quickly (~1hr), although i didn't have to break the bolt initially because it was already loose I guess the old clutch may have been good just loose? I replaced it any way. After replacement i drove it around for about 30-45 min with AC on max and trying to drive it pretty hard. Its hard to tell but it does seem to have more fan noise particularly when the engine is revved up higher. I was not able to get the temp to go over 100ºF (it was 98ºF here today) even in traffic when it would do that before and I would have to hit the heat. Hopefully all is well.


Now on to the AC pressure switch and dryer replacement.

Thanks,

G