View Single Post
  #3  
Old 02-19-2017, 11:49 AM
moruzzi moruzzi is offline
Registered User
 
Join Date: Nov 2003
Location: MA
Posts: 217
Still don't have the dam handle actuator out, but a bit more info.

Remove exterior plastic trim (license light piece) 2 screws from outside and 2 8mm nuts inside. Now handle actuator is loose, snap off the two actuator rods, and pull vacuum line. Create some more room by pulling the door latch (with close assist) 3 bolts from inside now pull the lower trim (I think it was 8 plastic pop out rivets) and remove the last 2 bolts, t2 electrical connectors and out it comes.

Dam latch is still stuck, can't (yet) find a way to get it past the metal.....

Anyone else done this??
Paul
Reply With Quote