Quote:
Originally Posted by Cody
I have an OM606 NA out of a 96 E300. I am in the process of acquiring all of the fittings and supplies i need to make a pop tester in order to bench test the injectors using a bottle jack. The only fitting I can't find because I do not know what it is called needs to go into a 1/4" female NPT on one side, and on the other end one of the injector lines off the car need to screw onto it. I would really appreciate if someone could help me find the fitting I need.
|
I am not sure what info was posted in the other post. However, you can obtain the injector end of the fuel injection Hard line with the nut that comes with it and cut it to the length you want and insert the cut end (rough up the exterior of the tube and smear JB Weld on it) into a brass fitting that has the external 1/4"npt threads.
You may need to drill out the inside diameter of the fitting so the cut end of the fuel injection hard line will fit.
Or the above could be done and the fuel injection hard line silver soldered while it is inside of the fitting instead of the JB Weld epoxy.